Do you have any set::allowed-nickchars set?
No.
I did do a fresh download and install and now everything seems to work fine. I even used the unrealircd.conf from the previous installation.
Very strange: on the old installation the problem persisted even after a 'make clean' and a re-compile. I ...
Search found 4 matches
- Fri Sep 28, 2007 10:05 am
- Forum: Unreal 3.2 Support
- Topic: IRCd stopped working and cannot start
- Replies: 6
- Views: 1799
- Thu Sep 27, 2007 8:21 am
- Forum: Unreal 3.2 Support
- Topic: IRCd stopped working and cannot start
- Replies: 6
- Views: 1799
Re: IRCd stopped working and cannot start
I just had some time to see if there was something wrong with the server and as a desperate measure I even rebooted it. The server itself is working fine, but the IRC daemon still refuses to start. Here are the last lines from the log (addresses obscured):
[ Wed Sep 26 10:33:42 2007] - Connect ...
[ Wed Sep 26 10:33:42 2007] - Connect ...
- Wed Sep 26, 2007 6:20 pm
- Forum: Unreal 3.2 Support
- Topic: IRCd stopped working and cannot start
- Replies: 6
- Views: 1799
Re: IRCd stopped working and cannot start
What are the last things in ircd.log? If you changed from the default ircd.log with a log block in your conf, be sure to check that log instead because that's where the error would be.
Does Unreal show in ps?
The last entries in the log show the connections that were established this morning ...
Does Unreal show in ps?
The last entries in the log show the connections that were established this morning ...
- Wed Sep 26, 2007 3:19 pm
- Forum: Unreal 3.2 Support
- Topic: IRCd stopped working and cannot start
- Replies: 6
- Views: 1799
IRCd stopped working and cannot start
Hi,
Until this morning Unreal IRCd 3.2.7 was functioning fine, but somehow stopped. When I tried to restart I got the output below. As you can see there are no real error messages to give an indication of what went wrong.
I even tried to compile with DEBUGMODE and then start IRCd, but that also ...
Until this morning Unreal IRCd 3.2.7 was functioning fine, but somehow stopped. When I tried to restart I got the output below. As you can see there are no real error messages to give an indication of what went wrong.
I even tried to compile with DEBUGMODE and then start IRCd, but that also ...