Page 1 of 1
HT-Mode: the value
Posted: Mon Jun 18, 2007 1:56 pm
by seraphim
The command:
/htm to <value>
Now i dont know what i have to set at the value, maybe kbits/sec? or kb/sec?
What is meant with this value?
Docs:
htm <option>
-TO <value> Tell HTM at what incoming rate to activate HTM
Posted: Wed Jun 20, 2007 6:22 am
by nate
Just to note, kbit and kb is basically the same thing, lower case kb or Kb is generally referred to as kilobits, KB is kilobytes. So I've always assumed they were measuring by kilobits.
Generally the default is like, 35kb/s or so I believe? I'd have to imagine you aren't going to exceed that default unless you are putting 250+ very active clients on a server, if not more than that if I recall correctly.
Posted: Wed Jun 20, 2007 1:30 pm
by seraphim
so this value have to be an number, kbits/s ?
Posted: Wed Jun 20, 2007 6:53 pm
by nate
Only a number, you don't need to specify 'kbit/s' after or anything, just a single number.
So if you wanted to put it at 40, you'd simply type 40.
Posted: Wed Jun 20, 2007 8:23 pm
by seraphim
k thx.