Registration Timeout Error

If you hit any installation issues or cannot connect to your freshly installed UnrealIRCd then this forum is for you.

Moderator: Supporters

Post Reply
Walaryne
Posts: 2
Joined: Mon Apr 29, 2019 4:34 pm

Registration Timeout Error

Post by Walaryne » Mon Apr 29, 2019 4:46 pm

Hi there,
I recently setup a Raspberry Pi with Arch Linux in order to run several services from it. Everything else seems to work fine aside from UnrealIRCd. I've attempted to install it from package repos and from source too, to no avail. The IRCd runs, but upon attempting to connect, from ANY location, including localhost and LAN IPs. I constantly get the same error.

Code: Select all

:irc.rynesnet.lan NOTICE * :*** Looking up your hostname...
:irc.rynesnet.lan NOTICE * :*** Couldn't resolve your hostname; using your IP address instead
ERROR :Closing Link: [10.0.0.1] (Registration Timeout)
Connection closed by foreign host.
I this is the result of a Telnet connection to the server. All clients I have attempted to use result in the same error.
I am entirely confounded at where the error is. I have even gone as far to flush all IPTables entries. I've even recompiled on my laptop and ensured the config runs without error there.

I sincerely hope someone can help me solve this issue.
Thanks,
Walaryne

k4be
Posts: 29
Joined: Sun Jan 09, 2005 12:19 pm
Location: Poland

Re: Registration Timeout Error

Post by k4be » Mon Apr 29, 2019 4:58 pm

It's normal with the telnet client if you had not sent anything. Try the sequence:
USER x x x x
NICK xxxx
Then reply to the PING request (replace PING with PONG).
Don't know why there's the error with usual IRC clients though.

Syzop
UnrealIRCd head coder
Posts: 1868
Joined: Sat Mar 06, 2004 8:57 pm
Location: .nl
Contact:

Re: Registration Timeout Error

Post by Syzop » Mon Apr 29, 2019 5:21 pm

Do you have a failed session from an actual IRC client with hh:mm:ss timestamps for us? (copy-paste here)

Have you set some kind of weird value for set::handshake-delay perhaps?

Walaryne
Posts: 2
Joined: Mon Apr 29, 2019 4:34 pm

Re: Registration Timeout Error

Post by Walaryne » Mon Apr 29, 2019 6:09 pm

No, the timeout occurs after 20 to thirty seconds approximately. (It should be whatever the default registration timeout value is.)
I have not changed the handshake delay.
As for raw Telnet commands, I could try, but as far as I know, the server will not respond.
I can get you a timestamp from Hexchat later.
EDIT: I forgot to mention the failed session from the IRC client is the same output from Telnet 1:1.

Post Reply