Req: Delayed join mode

These are old archives. They are kept for historic purposes only.
Post Reply
bashgeek
Posts: 3
Joined: Sat Dec 23, 2006 11:59 am

Req: Delayed join mode

Post by bashgeek » Sat Dec 23, 2006 12:04 pm

Hi guys (and maybe girls),

i've been searching for a module (channel mode) that reacts like the +D/+d channel mode in the Asuka server (used by quakenet).

Here a short description from the asuka docs:
* Channel mode +D and +d
'Delayed join' mode, when set on a channel joins and parts for that
channel are squelched. A user will be 'invisible' in the channel
from other users until they speak, are opped/voiced or change the
topic. When the +D mode is cleared, 'invisible' users will not be
revealed, instead the +d mode will automatically be set by the ircd
if invisible users remain in the channel. +d will be automatically
removed when the last 'invisible' user either becomes visible or
leaves the channel. It is possible to see the 'invisible' users
on a channel by doing /NAMES -d.
Is there any module that works like this?

Can anybody write some? :)

Thanks in advance!

Best regards and merry x-mas,
bashgeek

Jobe1986
Official supporter
Posts: 1180
Joined: Wed May 03, 2006 7:09 pm
Location: United Kingdom

Post by Jobe1986 » Sat Dec 23, 2006 1:08 pm

Sounds very much like channel mode +u to me. Which does basically the same. Only users arnt shown in the channel's nick list.

bashgeek
Posts: 3
Joined: Sat Dec 23, 2006 11:59 am

Post by bashgeek » Sat Dec 23, 2006 2:32 pm

I've tested the mode +u.
Opers see: The messages (even if +m is set) normal users send, and the joins of the normal users.

Stealth
Head of Support
Posts: 2086
Joined: Tue Jun 15, 2004 8:50 pm
Location: Chino Hills, CA, US
Contact:

Post by Stealth » Sat Dec 23, 2006 4:58 pm

Sounds like a channel-side +I to me, which can be greatly abused...

bashgeek
Posts: 3
Joined: Sat Dec 23, 2006 11:59 am

Post by bashgeek » Sat Dec 23, 2006 7:53 pm

Hmm..
I just want to hide all joins and parts/quits in that channel.

Stealth
Head of Support
Posts: 2086
Joined: Tue Jun 15, 2004 8:50 pm
Location: Chino Hills, CA, US
Contact:

Post by Stealth » Sat Dec 23, 2006 8:20 pm

Then use mode +u :)

Post Reply