Page 1 of 1
change from @%+ to ~&@%+
Posted: Fri Jan 20, 2006 10:57 pm
by adataman
I would like to add the ~ and & to my ircd although i am not sure how to do it. Would someone please advise me the steps i need to do to change my ircd. Also, is it ok to change this once ircd is up already. I am fairly new to setting up everything. I set up ircd and services myself, just not that great at it yet. Thanks.
Posted: Fri Jan 20, 2006 11:32 pm
by Syzop
I guess you are on *NIX?
Simply re-run './Config' and anser 'y' when asked about PREFIX_AQ / the & and ~ prefixes.
And then run 'make' (and 'make install' if needed) again and restart the ircd.
Posted: Sat Jan 21, 2006 1:24 am
by adataman
ok, thank you. I will go ahead and change that. when i do the config, do i have to answer all the questions again like i were starting over again or will they be all the settings i currently have and i just want to make that one change.
Thanks
Posted: Sat Jan 21, 2006 3:27 am
by [UnDeRTaKeR]
they will be like your current settings,
so all you have to do is keep all the others and change the question
concerning the prefixes(PREFIX_AQ / the & and ~ prefixes like syzop said)