Hey have loaded m_levellimit.c using make custommodule MODULEFILE=m_levellimit also added it to config rehashed server checked the module is loaded with /module _-7:14pm-_ -hub.chattersworld.co.uk- *** levellimit - 1.0 (Limit access to a channel based on oper level) [PERM] [3RD]
when I do /mode #channel +P It dont set that mode also it never asked when i loaded it what oper level was required to enter rooms with +P
Any Help
levellimit
Re: levellimit
Are on the same server as where you loaded it?
It has to be loaded on all the servers in your network to work properly.
It has to be loaded on all the servers in your network to work properly.
Ex Network-Administrator
Re: levellimit
sort of yes i`ve put it on the 3 servers i own we have a linked outside server that its not on
Re: levellimit
README from levellimit:
Also, you should load channel mode modules on all servers, otherwise this can lead to desynchs (in other words: fuck ups).
Tech story:
If someone does this on a server with the module loaded:
MODE #CHAN +Pk N a
which basically is '+P N' and '+k a'... then this works well.. however once this mode is propagated to the other servers...
then the server which does not have the module loaded does not know +P is a parameter mode, and will think you did '+P' and '+k N' (=wrong key).
Stuff like that...
And if it's a hub it's even worse...
In general, it's best to load all modules on all servers. There are a few exceptions and specific circumstances when it's not absolutely necessary, though.
So like mode #chan +P N- Usage -
The syntax for the mode is simply, +P <level>. Level may be one of the following:
N - Network Administrators
a - Services Administrators
A - Server Administrators
C - Server Co-Administrators
o - IRC Operators
Also, you should load channel mode modules on all servers, otherwise this can lead to desynchs (in other words: fuck ups).
Tech story:
If someone does this on a server with the module loaded:
MODE #CHAN +Pk N a
which basically is '+P N' and '+k a'... then this works well.. however once this mode is propagated to the other servers...
then the server which does not have the module loaded does not know +P is a parameter mode, and will think you did '+P' and '+k N' (=wrong key).
Stuff like that...
And if it's a hub it's even worse...
In general, it's best to load all modules on all servers. There are a few exceptions and specific circumstances when it's not absolutely necessary, though.