host-on-oper not working!

DarkBlood · Post by **DarkBlood** » Sat Sep 10, 2005 3:30 pm

Somehow the host-on-oper doesn't work with services admins...

This is how it's set:

hosts {
servicesadmin "thehost.address";
host-on-oper-up "yes";
};
};

can anyone tell me what the problem is? unrealircd.conf doesn't detect any errors when I rehash...

Dukat · Post by **Dukat** » Sat Sep 10, 2005 6:25 pm

http://www.vulnscan.org/UnrealIrcd/faq/#68

DarkBlood · Post by **DarkBlood** » Sat Sep 10, 2005 7:19 pm

Awsome, worked. Thanks!

DarkBlood · Post by **DarkBlood** » Sun Sep 11, 2005 12:43 am

One more question...

Is there a way to automaticlly set the IDENT AND host?

It would look a bit better if it was [email protected]

you know

Darvocet · Post by **Darvocet** » Sun Sep 11, 2005 2:45 am

DarkBlood wrote:One more question...

Is there a way to automaticlly set the IDENT AND host?

It would look a bit better if it was [email protected]

you know

You can set them with the mIRC perform command or some scripting with /chghost and /chgident -- Like /chgident opernick services.admin

Jason · Post by **Jason** » Sun Sep 11, 2005 3:21 pm

If you use anope, check out HostServ, it can change your ident as well as your host.

DarkBlood · Post by **DarkBlood** » Sun Sep 11, 2005 9:11 pm

Hmm, wait.

In the unrealircd.conf

Is there something that I can put for IRCops to automaticlly perform?

I'm thinking like the "mirc perform" but a command to make IRCops automaticlly perform when they oper..

Darvocet · Post by **Darvocet** » Sun Sep 11, 2005 9:17 pm

DarkBlood wrote:Hmm, wait.
In the unrealircd.conf
Is there something that I can put for IRCops to automaticlly perform?
I'm thinking like the "mirc perform" but a command to make IRCops automaticlly perform when they oper..

I dont think so.